3301770
4.6 Power Management Setup Selections
„
ACPI Aware O/S
Set this value to allow the system to utilize the Intel ACPI (Advanced Configuration and
Power Interface) specification. The Optimal and Fail-Safe default setting is Yes.
„
ACPI Standby State
This option allows you to select the S1 ACPI states: S1.
The S1 state is the default setting.
„
Power Management/APM
Set this option to Enabled to run APM (Advanced Power Management).
„
Video Power Down Mode
Set this option to Enabled to allow the BIOS to power down the Video adapter and Monitor.
„
Hard Disk Power Down Mode
Set this option to Enabled to allow the BIOS to power down the Hard Disk.
„
Standby/Suspend Time Out (Minutes)
This option specifies the amount of system inactivity (in minutes) before the system will enter
Standby/Suspend state.
„
Display Activity
This option specifies if BIOS is to monitor activity on the display monitor in order to reduce
power consumption. When this option is set to “Monitor and there is no display activity for
the length of time specified in the value in the Full-On to Standby Timeout (Min) option, the
computer enters a power saving state. The settings are “Monitor or Ignore. The default
setting is “Ignore.
4-13
