61
To clone (transfer) data directly from one UBCD996T scanner to another UBCD996T
scanner, you must first connect the scanners to each other using the included
connection cables and a DB9 null modem adapter and for the rear port, a DB9
gender changer (neither included), available at most computer stores. Then you
must set one scanner as the source and the other as the target.
1. Select the Front Port for the Master. Select the Rear Port for the Slave or vice
versa.
2. Plug the 9-pin serial connector into the unit designated as the Rear Port.
3. Plug the smaller connector into the front port of the unit designated as Front
Port.
4. When you are ready to clone the scanner, press on the slave scanner
, then on the master scanner. The master scanner checks the
connection between the two scanners, then transfers its data to the slave
scanner.
5. When the transfer is complete, appears on both scanners. If the
transfer did not work, appears on the master scanner. Readjust the baud
rate to a lower setting and try again.
first
Complete
Error
