A SERVICE OF

logo

Reelmaster 5010 Series
Cutting Units (Rev. C)
Page 7 -- 5
Plastic Plug
Toro Part Number: 2410--30 (for 5 inch r eels)
94--2703 (for 7 inch reels)
This cap is used for placement into the side plate bear-
ing housing when the hydraulic reel motor is removed.
It prevents dirt and debris from entering the cutting reel
bearing area.
Figure 5
Cutting Unit Kickstand
Toro Part Number: 110--4088--03
The cutting unit kickstand is used to prop up the rear of
the cutting unit during service. Use of this tool prevents
the bedbar adjusting screws from resting on the work
surface.
Figure 6
Spline Insert Tool
Toro Part Number: TOR4112 (8 tooth for 5 inch reels)
TOR4074 (9 tooth for 7 inch reels)
Use spline insert tool for rotating cutting reel when
hydraulic motor is removed. Also use this tool for instal-
lation of threaded inserts into cutting reel shaft.
Figure 7
Cutting
Units