![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/4/88/488ecd17-30df-4a09-80f6-dd8f6a426c59/488ecd17-30df-4a09-80f6-dd8f6a426c59-bg5.png)
1 SAFETY
Familiarity with all equipment and proper training are required for the
safe operation of any mechanical device. Attempting to operate any
mechanical equipment improperly or without training creates a situation
that is potentially hazardous. Prior to operation, read the instructions and
safety precautions included in this manual and attached to the lift.
Become familiar with the proper use of all controls. Inexperienced
operators should receive instruction before attempting to operate or
maintain the machine.
Always follow the safety procedures set forth in this manual as well as all
applicable ANSI, OSHA, state and local regulations. Persons under the
influence of drugs, alcohol or prescription medications should not be
allowed on or near this equipment. Do not operate in areas where the
machine or its operator may come into contact with a live power source.
The information contained herein is provided to alert Bil-Jax customers to
the normal procedures for the operation and maintenance of the Bil-Jax
Model 3522A Articulating Boom Lift. This information is not intended to
be all-inclusive, nor is it to be considered legal advice. These procedures
are to be followed in the care and maintenance of the named Bil-Jax
equipment only.
For any questions concerning the safe use of this equipment, contact the
Bil-Jax Service Department at 800-537-0540 before attempting
operation.
The use of intelligence and common sense is the best practice in
following any safety policy.
SAFETY NOTICES
This manual contains a variety of notices that must be observed to
prevent the possibility of improper service, personnel injury or death, or
damage to the equipment.
DANGER
Warns of operation near electrical power sources that could lead to
personal injury or death.
WARNING
Describes conditions or practices that could lead to personal injury
or death.
CAUTION
Contains information important in the prevention of errors that
could damage machine or components.
NOTE: Contains additional information important for performing a
procedure.
3