Page 19
INSTALL THE LOWER GUIDE RODS:
1. Take the (2) Ø30mm Guide Rods with threaded holes at both ends (PN:731-2391), (2) Round Rubber
Bumpers (PN:731-2394), and (2) “T” shaped Bearing Tubes (PN:731-2390) from the packaging.
2. You will use (4) Spacer rings (PN:731-2397), (4) m10 x 25 Hex Head Bolts (PN:731-2333), and (4)
m10 Large Washers (PN:731-2396), to install the Guide Rods into the lower mounts. Use a 17mm
box wrench to install one bolt, washer and spacer onto one end of each rod. Slide the rods through
the front mounts taking care not to scratch rods.
3. Take one of the “T” shaped Bearing Weldments, and one of the Rubber Bumpers and slide them over
the end of one of the vertical rods (See Below). Now slide the horizontal Guide Rod through the
bearings of the “T” shaped Bearing Tube. NOTE: DO NOT force the bearing onto the rods this may
damage the bearings. Once the Bearing Weldment is on the rods, slide the rod through the back
mount.
4. Take 2 spacers, washers, and bolts, install them on the other end of the Guide rods. Using (2) 16mm
box wrenches tighten the fasteners.
