BRACKET INSTALLATION
The
Cart Collector attaches to a mounting bracket,
which is bolted to the tractor’s back plate. The same
bracket is used on the riding mowers and the lawn
tractors. Once bolted in place, the bracket never needs to
be removed. For lawn tractors, see Section A. For
tractors with 3 forward speeds, see Section B.
Section A: Bracket Installation on Lawn Tractor
1.
Remove the drawbar plate from the back plate of the
lawn tractor.
2. Install the bracket (figure 17) to the back plate
through the same holes where the drawbar plate was
bolted. Use the
~three
31X-16
x
I hex bolts and
locknuts (A, figure 18).
Figure 18.
A. Hardware
Section B: Bracket Installation on Tractor with 3
Forward Speeds and 23” Diameter Rear Tires
1. Install the bracket to the back plate as shown in
figure 19, using three
3/8-16
x
I hex bolts and
locknuts. In the top, center hole (A) install a 3/8 x
3/4 bolt and 3/8 locknut to prevent bracket being
used as a
drawbar.
9
A
CAUTION
Do not remove the existing drawbar. Do not use the
bracket as
a
drawbar.
1
Figure 19.
A. Top. Center Hole
2.
Install the decal, part number 1700346 (see first page)
to top of bracket beside hole (A, figure 19).
ASSEMBLY OF FRAME AND COVER
1. Install the frame (A, figure 20) at four locations (B)
with 5/16-18
x
I-112
capscrew, washer and nut.
Install spacers (F) at top capscrew on each side (see
figure
8).
2. Attach the bracket (C, figure 20) with
two
5/
16-18
x
l-3/4 bolts (B), washers and nuts. Attach strap(E)
Figure 20.
A. Frame
6. Fastener Locations
C. Bracket
D.
son
E. Strap
F. Spacer
