6. Install wing nut (G, figure I) assembly as follows.
Insert
5/
16-18
x2-1/2&p&w
and 5/
i6flat
washer
from inside the deck. Place the cup (H) onto the
capscrew and install
S/
16
lockwasher and 5/ 16 nut.
(Figure 12 shows correct position ofcup.)Thread the
wingnut (A, figure 6) onto capscrew and install the
5/ 16 locknut (D) flush with end of screen.
7.
The belt retainer (A, figure 5) must be positioned
correctly. Loosen the nut(B) and position the leg(C)
so it is against the side of the idler arm (D). Then,
tighten the nut (B).
Figure 6.
A. Wing Nut
E. Belt Retainer
c. Pulley
D. Locknut,
S/,6
Figure 5.
A. Belt Retainer
6.
Nut
c.
Leg
D. Idler Arm
E. Notch
F. Spacer
G. Small Spacer
H. Stral, Notch
8. Install the blower assembly (figure 5) onto mower
deck as follows. Note that the notch(E) will be placed
onto small spacer(G) on top of the strap. The blower
assembly spacer(F) will tit into the strap notch(H).
a. Slide the
blowerintopositionasshowninfigure6.
and tighten the wing nut (A).
b. Push the belt retainer(B, figure 6) to provide slack
and install belt onto lower groove in pulley
(C).
(Rotate pulley while placing belt on.)
9. Place the deck drive belt in the upper groove of the
pulley (C, figure 6).
10. This completes installation of the blower assembly.
Install the tube and collection system by following
directions provided in this manual. To
remove the
blower assembly, see “Operating Without Collection
System.”
4
