Sharp XE-A147 Manual

A SERVICE OF

next previous

74

SD CARD FUNCTION

The register’s data can be saved to the SD memory card, and the programming data can be loaded from the SD

memory card.

To use the SD card function, turn the mode switch to the Z/PGM position and perform the corresponding

operations.

■

Inserting and removing an SD memory card

The SD card slot is located on the right side of your register.

Inserting an SD memory card

Insert an SD memory card into the SD card slot with the printed SD logo facing

upwards. Push the card in steady with a finger until it clicks and release it slowly.

Removing the SD memory card

Push in the card gently with a finger and release it. The card will come out.

NOTE

 •ThismodelsupportsSDcardsonly.UseofanyothertypesofSDcardssuchasminiSD,microSD,

etc.withanadapterisnotsupported.

 •WheninsertingorremovingtheSDmemorycard,besuretoreleaseitslowly.Otherwise,thecardmay

popoutandinjureyourfinger.

 •NevertouchorremovetheSDmemorycardwhileitisaccessed,otherwisethedatastoredinitmay

bedamaged.

 •FormattingtheSDmemorycarderasesallthedatainit.

Caution: Never turn the power off, while the SD memory card is accessed.

■

SD card formatting

When the SD card is not formatted yet, take the formatting operation.

s A@s

140

The master folder “SHARP/ECRXXX14” is created for the data file.