15
Grill
The grill pan and grid should be washed in hot
soapy water. After grilling meats or any foods
that soil, leave to soak for a few minutes in the
sink immediately after use. Stubborn particles
may be removed from the grid by using a nylon
brush.
The Ovens
Cleaning is easier if carried out while the oven
is still warm. Before cleaning, cover the burner
to prevent the burner holes becoming blocked.
The inside of the oven and inner door panel
can be cleaned using any cleaner bearing the
Vitreous Enamel Association (VEA) label.
Take care not to disturb the oven thermostat
temperature sensor at the top of the oven
opening.
thermostat temperature sensor
The enamelled oven burner trim (supplied with
some models only) can be removed for
cleaning.
The oven burner trim hooks onto the front of
the oven burner bracket.
When refitting make sure that the trim is in the
middle of the front of the oven burner bracket.
The Oven side linings
The oven has removable oven side lining panels
that have been coated with special enamel that
partly cleans itself. This does not stop all marks
on the lining, but helps to reduce the amount
of manual cleaning needed.
The self cleaning panels work better
above gas Mark 6. If you do most of
your cooking below this temperature,
occasionally remove the panels and
wipe with a lint free cloth and hot
soapy water. The panels should then be
dried and replaced and the oven
heated at Gas Mark 7 for about one
hour. This will ensure the self cleaning
panels are working effectively.
Don’t use steel wool (Brillo) or any other
materials that will scratch the surface. Don’t use
oven cleaning pads.
Before cleaning the oven, cover the burner at
the rear to stop the holes getting blocked as you
clean. If they are accidentally blocked, clean
them out with thin wire, such as fuse wire.
Removing the Oven Linings
The lining panels can be removed for cleaning
and for cleaning behind. Remove the shelves
first.
Each side of the oven is fixed with four fixing
screws. You don’t have to remove the screws to
remove the oven linings. Lift each side panel
upwards and they will slide off the screws. Then
pull them forwards.
Once the linings are removed, the oven enamel
interior can be cleaned.
