4. Configuration
4-4 June 2004 4200-A2-GN21-30
GranDSLAM 4200 Startup Procedure
You can initialize your GranDSLAM 4200 via a PC or terminal connected to the
unit’s CONSOLE port. Then, using a series of CLI commands, GrandVIEW EMS
or another Element Management System, or the web interface, you can configure
the unit according to your requirements.
Login
Procedure
To log in to the GranDSLAM 4200:
1. Connect a PC or terminal to the CONSOLE port. (See Console Port in
Chapter 2, Cabling.)
2. At the login> prompt, type admin and press Enter.
3. At the password> prompt, press Enter. The default login password is blank.
4. At the PDYN> prompt, type privilege and press Enter.
5. At the password# prompt, press Enter. The default privileged password is
blank.
You are now logged on and in privileged mode, which allows you to configure the
unit.
Management Modes
The startup procedure for the GranDSLAM 4200 system differs depending on the
type of management used:
Inband Management – Operates over the uplink.
Out-of-Band Management – Operates over Port 1.
