A SERVICE OF

logo

Open as PDF
next previous
66
Setup
■ Setting the SCSI ID number
In most cases, there is no need to change the default settings (see Tables 1
and 2 below).
However, if you have other peripheral devices connected in a SCSI chain,
check if their ID numbers conflict with that of the printer or scanner. Be sure
to choose an unassigned ID number.
SCSI ID number can be changed by using the scanner SCSI ID No.
switches (#1, #2, #3) [see Table 1 below] and/or printer SCSI ID No.
switches (#2, #3, #4) [see Table 2 below]. To set them, use a pointed object
like a pen (do not use pencil).
Table 1 (scanner)
Table 2 (printer)
SCSI ID
No.
SCSI ID No. switches
#1 #2 #3
0 OFF OFF OFF
1 ON OFF OFF
2 OFF ON OFF
3 ON ON OFF
4 OFF OFF ON
5 ON OFF ON
6 OFF ON ON
7ONONON
SCSI ID
No.
SCSI ID No. switches
#2 #3 #4
0 OFF OFF OFF
1 ON OFF OFF
2 OFF ON OFF
3 ON ON OFF
4 OFF OFF ON
5 ON OFF ON
6 OFF ON ON
7ONONON
Setting the SCSI ID
number and
terminator
1234
ON
OFF
ON
SCSI ID No. switches
Terminator switch
1234
ON
OFF
SCSI ID No.
switches
Terminator switch
: Default setting
: Default setting
Example:
SCSI ID No.=2
Terminator=OFF
Example:
SCSI ID No.=1
Terminator=ON