DCA-180SSJU — OPERATION AND PARTS MANUAL — REV. #3 (02/01/10) — PAGE 55
1
1. Perform steps 1 through 6 in the section
as outlined in the .
2. Place the (Figure 56) in the HIGH
position
4. Continue operating the generator as s outlined in the
procedure (start at step 5).
Figure 57. MPEC Control Switch (AUTO)
When running the generator in the AUTO mode, remember
the generator can start up at any time without warning.
NEVER attempt to perform any maintenance when the
generator is in the auto mode.
WARNING - AUTO MODE MAINTENANCE
GENERATOR START-UP PROCEDURE (AUTO MODE)
When the MPEC
is placed in the AUTO position,
the engine glow plugs will be
warmed and the engine will start
automatically.
NOTE
When starting generator in AUTO mode use the "
Start-up" procedure except where noted (see below).
CAUTION - ENGINE SPEED SWITCH
The must be set to the “High”
position when running in the mode. Failing to
set the switch in the proper position can result in damage
to your generator when it turns on.
3. Place the (Figure 57) in the
AUTO position
Figure 56. Engine Speed Switch (High)
