VFD Menus Chapter 5
MPC User Manual Rev 0D 47
directly with each other.
• GATEWAY: The address of the device that will transfer messages out of
the local network to the internet.
• COMPUTER: Give your MPC a network name (8 characters maximum).
5.2.5 Configure Modem
The CONFIG MODEM functionality group allows you to configure the internal modem connection
with the MPC. Figure 41 on Page 47 shows the CONFIG MODEM menus.
Figure 41: Config Modem Menus
As seen from Figure 41, there are two CONFIG MODEM menus. One is for a client connection, see
also Section 4.2.2, Modem or Direct Connect (PPP) Client on Page 26, and the other is for a host
connection:
• CONFIG MODEM (Client)
• PHONE: The phone number of the service that the MPC is to call.
• PC COM: The communication parameters for the MODEM port.
• PROTO: The network protocol. The two choices are Point-to-Point (PPP)
or Serial Line Internet (SLIP) Protocol.
• USRNAME: The MPC’s client user name on the remote network.
• PASSWRD: The password for the above client.
• SOURCE: ‘YES’ or ‘NO’ depending on whether or not respectively the
IP address is assigned automatically by the host computer. If AUTO IP is
changed to ‘YES’, then the IP row will not be editable and anything in
the IP ADDR row will be deleted.
• IP ADDR: The internet protocol (IP) address.
CFG MODEM HOST
IP START
IP STOP
000.000.000.000
000.000.000.000
ASSIGN ASSIGN IP:NO
CONFIG MODEM
PHONE
PC COM
19002446262
TYPE:PPP
USRNAME USERNAME4
PASSWRD PASSWORD4
PROTO
IP ADDR 000.000.000.000
SOURCE AUTO IP:NO
57600 8 NONE 1 N
