57
206-4218
Conguration Options via Command Line (Cont.)
Example: Output IP Configuration Menu
----------------------------
IP Output Configuration Menu
----------------------------
display Display output IP configuration
set Configure output IP channel
fill Fill IP configuration with autoincrement IP
ttl Set the multicast TTL
*
apply Apply the new IP configuration
exit Return to the Setup Menu
IP Output Command >
Display Output IP Conguration
1. At the
IP Output Command >
prompt, type display and press Enter to view the
current output conguration, for example:
N IP Address Port
--- ------------- ----
1-1 227.0.0.0 1234
2-1 227.0.0.2 1234
3-1 227.0.0.4 1234
4-1 227.0.0.6 1234
5-1 227.0.0.8 1234
6-1 227.0.0.10 1234
7-1 227.0.0.11 1234
8-1 227.0.0.12 1234
TTL: 1
Note: The multicast TTL is displayed only if the OAT100R software is version 2.0 or later.
2. At the
IP Output Command >
prompt, type exit and press Enter to return to the Setup
Menu when you are nished reviewing the display.
Manually Configure Output IP Channels
This option enables you to specify the multicast IP address and port number for each program.
Each program must be assigned a unique IPv4 multicast address. See “Channel Assignments
for IP Output” on page 9, and/or check with your service representative, if necessary.
Note: If you wish to set a base multicast IP address and have the system auto-increment the
remaining program data, use the “fill” option described below.
1. At the
IP Output Command >
prompt, type set and press Enter.
(Continued on next page)
* Available only with OAT100R version 2.0 or later software.
