Using the Wireless Setup Utility
9
5 Select the appropriate encryption for the network. The type of encryption that can be used is
dependent on the authentication type that was selected in step 4.
For Open:
• No Encryption
• WEP
For Shared:
• WEP
For WPA Personal:
• TKIP
For 802.1x–RADIUS:
• No Encryption
• WEP (dynamic keys)
• WEP (static keys)
• WPA-TKIP
6 If 802.1x–RADIUS using EAP-TLS is the intended authentication type, a certificate request
is needed to obtain a signed certificate for the device. For instructions on requesting a new
signed certificate, see Creating a certificate request. If a different 802.1x–RADIUS
authentication mechanism is used, skip to step 7.
7 Configure authentication and encryption. If none of the following options are selected,
continue to step 8.
If 802.1x–RADIUS was selected as the authentication type, click Configure
Authentication, and follow the Configuring the authentication mechanism instructions.
If WPA Personal was selected as the encryption type, click Configure Encryption, and
follow the Configuring WPA Personal encryption instructions.
If WEP or WEP (static keys) was selected as the encryption type, click Configure
Encryption, and follow the Configuring WEP encryption instructions.
8 Click Apply.
9 Click OK.
10 Click OK to close the utility.
Configuring the authentication mechanism
• If EAP-MD5, MSCHAPv2, or LEAP is selected as the authentication mechanism:
1 Enter an appropriate username and password for the 802.1x–RADIUS authentication
server.
2 Confirm the password.
