Boot Code Requirements for ProCurve Software Release Notes for 07.8.04
6
Table 5: Boot Code Requirements
Routing
Switch
Modules Software Image Minimum Boot Code
Required
ProCurve 9304M
ProCurve 9308M
With one of the following
M1
1
modules (without
Redundant Management):
J4141A 10/100
J4144A Gigabit SX
J4146A Gigabit 4LX/4SX
HPR06636.bin
2
M1B07108.bin or greater
recommended
ProCurve 9304M
ProCurve 9308M
ProCurve 9315M
With any one or two of the
following Redundant
Management: modules
J4846A Gigabit SX
2
(M2)
J4845A Gigabit LX
2
(M2)
J4847A 0-Port
2
(M2)
J4857A Mini-GBIC (M4)
J4885A EP
J4879A T-Flow
For M2, M4, and EP
Redundant Management
modules:
- H2R07803.bin
For T-Flow Redundant
Management modules:
- TSP07801d.bin
For M2, M4, and EP
Redundant Management
modules:
- M2B07605.bin or greater
For T-Flow Redundant
Management modules:
- M2B07605.bin (all MP
images)
- VSB07100.bin (VSM code)
— 10 Gigabit Ethernet (10GE)
Modules
Note: To upgrade FPGA
code, refer to “Upgrading
the FPGA on a 10 Gigabit
Ethernet Module” on
page 11.
The Field-Programmable
Gate Arrays (FPGAs) in 10
Gigabit Ethernet Modules
use the following software.
J4891A FPGA:
rxbmgr.bin – version 80,
revision 6
rxpp.bin – version 81,
revision 16
txaccum.bin – version 82,
revision 6
txpp.bin – version 83,
revision 13
ageram.bin – version 84,
revision 4
J8174A FPGA:
xpp.bin – version 88, revision
37
xtm.bin – version 89, revision
39
Note: To determine the
FPGA versions running on a
10GE module, enter show
flash. The version
information is listed
separately for each 10
Gigabit Ethernet module in
the chassis.
10 Gigabit Ethernet modules
do not use any of the boot
images listed above.
ProCurve 6308M-
SX
—
HPR06636.bin
2
M1B07108.bin or greater
recommended
