47
Release Notes for 07.8.04 Software Fixes
63975 A routing switch in which ProCurve 9300M Series
modules are installed can sometimes reload due to
incorrect logic for lockup detection.
System 07.8.02
07.8.02d
62862 If RIP routes are configured and redistributed to
OSPF, when an interface that is learning RIP routes
is temporarily disabled, the RIP routes that are
redistributed to OSPF are removed correctly, but
are not restored when the interface comes back up.
RIP 07.8.02
63310 If IP multicast is configured, IP control packets in
the range 224.0.0.1 to 224.0.0.255 may be
incorrectly discarded.
System 07.8.02
64951 If SSH is configured and you reload the switch, the
configuration may sometimes reset due to invalid
length of SSH keys.
SSH 07.8.02
65342 The lockup detection mechanism is sometimes
applied incorrectly, resulting in a system reload.
System 07.8.02
65869 If the SuperSpan feature is globally enabled and
you remove the SuperSpan configuration at the
VLAN level, it is also removed at the global
configuration level.
SuperSpan 07.8.02
65957 During the reload of a routing switch on which
Policy Based Routing (PBR) is configured, the time
required to resolve next-hop ARP entries and
program the CAM is significantly longer, resulting in
a delay when accessing the console.
PBR 07.8.02
07.8.02f
34083 If BGP is configured, the switch takes a long time to
transmit the complete BGP route table to a
neighboring peer.
BGP 07.8.02
54245 When you delete CAM entries with MAC addresses,
a system reload may occur.
System 07.8.02
54250 If the Spanning Tree Protocol (STP) is configured,
the debug span all_802_1d_events vlan
<vlan_id> command is not parsed correctly as a
valid command.
Spanning Tree 07.8.02
54251 If the Rapid Spanning Tree Protocol (RSTP) is
configured, the debug 802.1w all_802_1d_events
vlan <vlan_id> command does not send debug
events to a console, Telnet, or SSH session.
RSTP 07.8.02
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed
