Installation Procedures 15
ENWW
For more information, see the applicable HP Jetdirect
Administrator’s Guide on the HP Jetdirect CD-ROM.
● Use the printer’s control
panel (for printers with a
supported control panel)
to configure basic network
parameters on the print
server. See Appendix C
for
more information.
● For TCP/IP networks, use an
advanced configuration method,
such as BootP, DHCP, Telnet, or
the “arp” and “ping” commands.
For instructions, see the HP
Jetdirect Administrator’s Guide
for this print server included on
the HP Jetdirect CD-ROM.
● Use HP printer management software (such as HP Web
JetAdmin) or other network utilities to configure network
parameters. HP printer setup and management software can be
downloaded from HP’s online support at:
http://www.hp.com/support/net_printing
Note After the print server is configured with network
parameters, the configuration values are saved and
maintained even after the printer is turned off and
back on again.
?
MENUS
+XXXXXXXXXX
+XXXXXXXXXXXX
+XXXXXXXX
a
r
p
-
s
T
e
l
n
e
t
B
o
ot
P
D
H
C
P
EIOSG.book Page 15 Thursday, October 9, 2003 1:42 PM
