MO295-en-GB_1.7 3/15
7
Moisture Alarm Set Procedure:
1. With MOIST displayed, simultaneously press the MOIST and MODE buttons.
2. The “HIGH” icon will appear on the display.
3. Press the ▲or ▼button to set the high limit desired.
4. Press the STORE/ALARM SET button to save the value and proceed to the LOW set value.
5. With the “LOW” icon in the display, Press the ▲or ▼button to set the low limit desired.
6. Press the STORE/ALARM SET button to save the value and to return to the normal mode.
7. If the moisture measurement is higher than the LOW alarm setting, the meter will beep once
every second
8. If the moisture measurement is higher than the HIGH alarm setting, the meter will beep
continuously.
Memory Mode
Saving Readings:
1. With the meter in the desired measurement mode, press the STORE button for 2 seconds until
the unit beeps to save a reading into the internal memory. The numeric display above the MEM
icon will indicate the memory location the reading is stored to.
2. When the 20 memory locations are full, the unit will overwrite old saved readings starting with
memory location 01.
Recalling Stored Readings:
1. Press the ▲and ▼buttons simultaneously to display stored readings. The numeric display
above the MEM icon will flash.
2. Use the ▲or ▼button to scroll through the memory locations.
3. To return to normal operating mode, press the STORE button.
Clearing Stored Data:
1. To clear stored data, press and hold the ▲and STORE buttons simultaneously until CLR
appears on the display.
Auto Power Off
The meter will enter a sleep mode after 30 minutes of inactivity. The meter will emit a warning beep 15
seconds before shutting down.
To disable the APO feature, press the MODE button when turning the meter ON. The “APO” icon will
not appear, indicating it is disabled.
Change Temperature units from F to C or C to F
1. Press the power button to turn the meter on.
2. Press the IRT button to turn on the IR thermometer and then release the button.
3. Press the ▲or ▼button to set the desired temperature unit
