EPL-N2700 Revision A
Troubleshooting Overview 83
none of the paper source has paper in it, the message “Manual
Feed ssss ttt” is indicated again. Even though the fed paper size
does not match ttt, “Check Paper Size” is not indicated.
Remove Output Paper (error)
When the multibin mode is changed from the previous one, paper
remains in the multibin unit.
<Remedy>
Remove all paper in the multibin unit, and the error is automatically
cleared.
Can’t Print Duplex (error)
Duplex print is not available due to restricted matter on the duplex
print.
<Remedy>
Press the Continue button, and the printer starts single printing. If
“Auto Cont” in the Config menu is activated, the printer starts single
printing after specified period of time. In case the error relates to the
paper source device, the printer may starts duplex printing when the
device’s condition changes and the error is cleared.
Invalid option (error)
The option currently installed is not supported by the printer.
<Remedy>
Turn the printer off and remove the corresponding option.
Check Paper Type (warning)
When “Paper Source” is set to “Auto” and paper type is specified,
none of the paper sources holds paper whose size and type both
meet the selected paper size and type. So the printer loads paper
from the paper source which holds the paper that does not match
the selected paper type but the size only. In case the paper source
set for the paper of the selected paper size and type is empty,
“Paper Out” error occurs instead of this warning.
Outbin Select Error
The output device used is other than selected one because the
selected device is restricted.
3.1.2 Service-call Error
The service-call errors fall into two categories; engine related and
controller related, as described in the next sections.
3.1.2.1 Engine Related Error
The following table lists the engine related errors which can occur in this
printer.
Table 3-2. Engine Related Error List
Error Code Description
E0004 Main motor error
E0005 Fan motor error
E0006 Polygon motor error
E0008 Engine EEPROM error
E0014 Error in communications with engine
E0015 Error in communication with option
E0030 Fuser error (time-out)
E0032 Fuser error (overheat)
E0034 Fuser error (low temperature error)
E0041 IU motor error
E0046 HSYNC detection error
E0047 IU fuse blown error
