Product Descriptions
Rev. A
1-2
Panel Functions (Normal Usage)
Button Function
Available
Condition
Comment
Operate Power On/Off Always
At turning the printer off, the printer executes
capping function before the power down.
Pause Pause/Non-Pause Always
Pause
(5 seconds)
Reset Pause/Standby
The function will be recognized with this
button held down for more than3 seconds.
LF/FF LF/FF Pause/Standby
Load/Eject Load/Eject Pause/Standby
↑
Micro Adjust
Micro adjust
(Forward feed)
Pause/Standby See Note below.
Micro Adjust
↓
Micro adjust
(Reverse feed)
Pause/Standby See Note below.
Cleaning (Black)
(3 seconds)
Cleaning (Black) Pause/Standby
The function will be recognized with this
button held down for more than 2 seconds.
Cleaning (Color)
(3 seconds)
Cleaning (Color) Pause/Standby
The function will be recognized with this
button held down for more than 2 seconds.
Media Type Selects paper type. Pause/Standby
Note) TOF (Top Of Form) adjustment
When ”Micro adjust” is executed for the TOF position, the adjusted TOF position is memorized in
the EEPROM. TOF positions for the ASF, manual insertion and tractor are stored in the
corresponding addresses of EEPROM.
Tear off adjustment
When “Micro adjust” is executed for the tear off position, the adjusted tear off position is
memorized in the EEPROM.
Panel Functions with Power On
Button Function Comment
Pause Enters the printer adjustment mode. Refer to Section 1.5.3.
LF/FF Enters LQ self-test print mode. Refer to Section 1.5.5.
Load/Eject Enters draft-self test print mode. Refer to Section 1.5.5.
Media type Enters the default setting mode. Refer to Section 1.5.2.
LF/FF
+
Load/Eject
Enters the hex-dump mode. Refer to Section 1.5.6
Pause
+
LF/FF
+
Micro adjust ↓
Performs EEPROM and IC reset. Initializes Timer IC and a part of
the EEPROM.
Note) ”+” means to press one button while holding down the other button(s).
The power switch is connected to the secondary side of the electrical circuit. Since it has a delay
circuit, voltage is still applied for the specified period of time after the printer power is turned off.
As long as the printer is plugged in, voltage is applied to the primary side of the electrical circuit.
Therefore be sure to unplug the printer before servicing or replacing the interface.
When the EEPROM is reset, the waste ink drain pads need replacing. This must be performed by
a qualified service person only. (See Chapter 3.)
Table 1-28. Panel Functions
Table 1-29. Panel Function with Power On
CAUTION
