A SERVICE OF

logo

Open as PDF
next previous
EPSON Stylus COLOR 3000
Rev. A
4-1
7
4.1.9.1 PQ Sensor Adjustment
Follow the steps exactly in the way instructed. Otherwise the fatal error will occur.
Inaccuracy in this adjustment does not guarantee the proper operation of the printer.
1. Enter the
“Sensor Check”
menu. (See Section 4.1.9.)
2. Move the cursor using ↑ or ↓ key to select
“1.CR-PWS”
and press “Return key.
3. Move the cursor using ↑ or ↓ key to select
“2. ASF Quantity”
. and press “Return” key.
4. Remove paper and press “Return” key.
5. Set a stack of paper * or the paper quantity detective adjust tool on the right edge guide in the ASF.
Then press “Return” key, and the Sensor check menu appears.
Note) Stack of paper: With a thickness of 9 mm to 9.1 mm or approximately 100 sheets of 64-g paper
(17-lb. paper)
CAUTION
PQ Sensor Lever
Paper Quantity Adjusting Tool
Right Edge Guide
9 mm
Figure 4-10. Setting the Paper Quantity Detective Adjust Tool