Configuring L2 Bridge Mode | 42
Note: After registering new Dell SonicWALL appliances on
MySonicWALL, you must also register each appliance
from the SonicOS management interface by logging
into the unique IP address assigned on the High
Availability > Monitoring page and then clicking the
registration link on the System > Status page. This
allows each unit to synchronize with the license server
and share licenses with the associated appliance.
Associating Pre-Registered Appliances
To associate two already-registered Dell SonicWALL appliances
so that they can use HA license synchronization, perform the
following steps:
1. Login to MySonicWALL.
2. In the left navigation bar, click My Products.
3. On the My Products page, under Registered Products,
scroll down to find the appliance that you want to use as
the parent, or primary, unit. Click the product name or
serial number.
4. On the Service Management - Associated Products page,
scroll down to the Associated Products section.
5. Under Associated Products, click HF Secondary.
6. On the My Product - Associated Products page, in the text
boxes under Associate New Products, type the serial
number and the friendly name of the appliance that you
want to associate as the child/secondary/secondary unit.
7. Select the group from the Product Group drop-down list.
The product group setting specifies the MySonicWALL
users who can upgrade or modify the appliance.
8. Click Register.
Configuring L2 Bridge Mode
This section provides instructions to configure the Dell
SonicWALL NSA E6500 appliance in tandem with an existing
Internet gateway device. This section is relevant to users
following deployment scenario C.
This section contains the following subsections:
• Connection Overview - page 43
• Configuring the Primary Bridge Interface - page 43
• Configuring the Secondary Bridge Interface - page 43
If You Are Following
Scenario...
Proceed to:
B - NAT with State Sync Pair Additional Deployment Configuration -
page 46
