AutoDome Easy Installing the AutoDome Easy 11
Bosch Security Systems, Inc. Installation and Configuration Manual December 06, 2006 | F01U032279
8 Installing the AutoDome Easy
This chapter details how to install the AutoDome Easy for an in-ceiling, wall, or pipe mount.
8.1 Surface Mount
The mounting plate (included) is used for ceiling installation. The unit may be mounted to a
hard surface or to a suspended ceiling tile.
Fig. 8.1 Ceiling Mount Installation
8.1.1 Preparing the Drywall Ceiling for Installation
To mount to a surface, follow the steps below:
1. Determine a proper location for the dome.
2. Use the supplied mounting bracket as a template to mark the three (3) mounting hole
locations on the ceiling.
3. Locate the curved indentation (see Figure 8.1, Reference # 5) to mark the center of the
hole.
i
NOTICE! The image sensors in modern CCD cameras are highly sensitive and require special
care for proper performance and extended lifetime. Follow the guidelines for optimum results
with your camera:
• Do not expose to direct sunlight or bright spotlights in operating and nonoperating
conditions.
• Avoid bright lights in the field of view of the camera. Bright lights cause a "smearing"
effect, which is visible as white lines above and below the highlight. Prolonged expo-
sure to bright lights may cause bleaching of the sensor's color filters. This will be vis-
ible as colored spots in the picture and is irreversible.
Reference # Description
1 Mounting Holes
2 Plastic Mounting Anchor
3 Front (Locking Tab)
4 Cable Hole (40 mm maximum)
5 Indentation
6 Mounting Bracket
7 M4 x 25 Tapping Screws
4
0.0 mm
90.0 mm
1
2
5
6
4
4
3
1.57 in.
3.54 in.
