B. Pass the L.E.D. wires through
the hole from the front of the
panel, and press the body of
the L.E.D. into the hole until
fully seated.
WIRING THE SYSTEM
Making the connections to the
vehicle, as described in this
wiring section, may be beyond
the technical abilities of the
average consumer. If you have
any questions with the wiring
procedures, please call a quali-
fied automotive technician, or
call the AUDIOVOX HOT LINE at 1
- 800 - 225 - 6074. Prior to
COURTESY
LIGHT FUSE
A
SPLICE INTO
WIRE AND
WRAP WITH
ELECTRICAL
TAPE
B
FUSE BOX
FUSE CLIP TERMINAL
(NOT INCLUDED)
RED WIRE
RED WIRE
BLACK WIRE
SIREN MOD-
ULE
NEGATIVE TERMINAL
siren control module should
remain disconnected during the
wiring portion of the installa-
tion. Leaving this disconnected
will ensure that the keychain
transmitters are properly pro-
grammed later in the installa-
tion.
1. Routing The Wiring Har-
ness
The DARK BLUE wire must be
routed through the firewall,
and into the passenger compart-
ment of the vehicle, towards
the dash L.E.D. In most cases,
the RED wire will also be routed
into the passenger compart-
ment, to the courtesy light
fuse. Before proceeding with
the wire routing, verify the
location of the courtesy light
fuse, as a small percentage of
vehicles locate this fuse in
the engine compartment, and in
these cases, it will not be
necessary to route the RED wire
through the firewall.
After confirming these compo-
nent locations, route the DARK
BLUE and RED wires towards
their connection points. Cau-
tion should be used when rout-
ing wires. Keep wires away from
all hot surfaces, and any mov-
ing parts of the vehicle (
radiator fans, accelerator or
brake pedal linkage, etc. ).
When routing wires through the
firewall, be sure to pass the
wires through an existing rub-
ber grommet. Failure to do this
making any connections, a 12
Volt logic probe should be used
to confirm the proper connec-
tion point.
IMPORTANT ! The 4 pin white
connector on the end of the main
harness that plugs into the
Page 2
