3
PREPARATION
Before Use
1. Verify that the product and application are compatible, if in doubt call Atd Tools Technical Service line (636)
327-9050
2. Before use, read the operator's manual completely and familiarize yourself thoroughly with the product and its
components, and recognize the potential hazards associated with its use. Know your jack and how it operates
before attempting to use.
Assemble handle
Attached handle to the handle bracket on cylinder set with bolt and nut provided. Refer to parts drawing (page. 6)
for component location.
Prepare air system
CAUTION: Air source must not exceed 200 psi maximum.
1. Connect a union tting (sold separately) to the air supply inlet (ref. Fig. 2).
2. Attach 1/4" NPT coupler (sold separately) to union tting if desired.
3. Frequent, but not excessive lubrication is required for best performance. Too much oil will collect inside jack and
be expelled during exhaust cycle. An automatic inline oiler is recommended, but oil may be added manually before
operation or after approximately 1 hour of continuous use. Pour 1 teaspoon of good quality air tool lubricant into
air supply inlet of control valve.
4. Dirt and water may accumulate inside jack during use. An inline lter/dryer is recommended.
5. Air Jack/Support Stand is now ready for use.
WARNING: Never use more than one extension with this unit. Using more than one extension causes the load
to be lifted beyond the maximum designed safety lifting height, which could cause loss of load.
Check the jack
1. Examine the jack for broken or damaged parts. Roll the jack to ensure that it rolls freely and smoothly.
2. Raise and lower the unloaded saddle throughout the lift range to ensure proper operation before placing any load
on the product.
3. Replace worn or damaged components with factory replacement parts only. (See Replacement Parts Section).
Lubricate as instructed in Maintenance Section.
Figure 1 - Air Jack/Support Stand Components
Wheels
Handle Grip
Air Control Valve
Lock Pins
Air Cylinder
Upper Post
Handle
Air Hose
Saddle
Low Post
Exploded Post
Lock Pin Holder
Post Holder
!
!
