SAFETY AND GENERAL INFORMATION
Save these instructions.
For your safety read, understand, and follow the information provided with and on this
jack. The owner and operator of this equipment shall have an understanding of this jack and safe operating pro-
cedures before attempting to use. The owner and operator shall be aware that use and repair of this product may
require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's native
language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack, remove
from service immediately.
Inspect before each use.
Do not use if broken, bent, cracked, or damaged parts (including labels) are noted. Any jack
that appears damaged in any way, operates abnormally or is missing parts, shall be removed from service immediately
and the manufacturer notied. If you suspect that the jack was subjected to a shock load (a load dropped suddenly,
unexpectedly upon it), immediately discontinue use until the jack has been checked by a factory authorized service
center (contact distributor or manufacturer for list of Authorized Service Centers). It is recommended that an annual
inspection be done by qualied personnel.
Replace worn or damaged parts with Factory Authorized Replacement
Parts only.
Labels and owner’s manuals are available from manufacturer.
PRODUCT DESCRIPTION
The ATD TOOLS 10 Ton Air Jack/Support Stand is designed to lift and support rated capacity loads. Intended use:
To lift one wheel or one axle of a vehicle for the purpose of service and/or repair of vehicle components. Use this
jack in pairs when lifting an entire end of a vehicle. Check with vehicle owner's manual for proper lift points. Use
one pair per vehicle.
WARNING: Rated capacity of this device is a reference to the working load this stand is capable of sustaining.
Rated capacity is not increased when jacks are used in mutiples.
WARNING: Do not use for any purpose other than those uses outlined in this manual. DO NOT use jack
around corrosive materials such as chlorides - commonly used by road crews to melt snow and ice. Water and
slush from vehicles exposed to chlorides may enter jack cylinder, severely and permanently damaging interior
of cylinder and causing air leaks which adversely affect lifting performance.
2
SPECIFICATIONS
Model Capacity
Starting
Height
Max. Lift
Height
Power
Travel
Jack Size
( L x W x H )
Rated Capacity
Air Pressure
ATD7350 10 Ton 17-1/2" to 40" 51-1/8" 11-1/2" 22" x 12" x 17" 200 psi
! WARNING
• Study, understand, and follow all instructions before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surfaces.
• Lifting device only. Immediately after lifting, support the vehicle with appropriate means.
• Do not move or dolly loads with this device.
• Lift only on areas of the vehicle as specied by the vehicle manufacturer.
• No alterations shall be made to this product.
• Failure to heed these markings may result in personal injury and/or property damage.
• Leer, comprender, y seguir las instrucciónes antes de utilizar el aparato.
• El manual de instrucciónes y la información de seguridad deben estar comunicado en lengua del operador
antes del uso.
• No seguir estas indicaciónes puede causar daños personales o materiales.
! ADVERTENCIA
!
!
