ARM DUI 0224F Copyright © 2003-2007 ARM Limited. All rights reserved. G-1
Appendix G
Configuring the USB Debug Connection
When you install the RealView
®
ICE Micro Edition software that is provided with
RVDS version 2.1 or higher, various features are added to the RealView
®
Debugger.
This appendix explains how to use these additional features to configure the PB926EJ-S
USB debug port connection, and how to connect RealView Debugger to the PB926EJ-S.
It contains the following sections:
• Installing the RealView ICE Micro Edition driver on page G-2
• Changes to RealView Debugger on page G-5
• Using the USB debug port to connect RealView Debugger on page G-6
• Using the Debug tab of the RealView Debugger Register pane on page G-10.
Note
This chapter assumes that you are familiar with how to use RealView Debugger to
connect to a target, and to configure a connection. For details, refer to the RealView
Debugger documentation suite (see the RealView Debugger v1.7 Target Configuration
Guide) and the RealView ICE User Guide.
