Pre:w CLOCIVDIMMER once, then press ENTER
W!in 4 seconds.
When using the remote control
Press CLOCK while pressing SHIFT, then press
llSETu!il.hh
4 seconds.
Turn MULTI JOG to designate the hour, then press
ENTER.
The hour stops flashing and the minute stark flashing.
Turr~ MULTI JOG to designate the minute, then
press ENTER.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To display the current time
Press CLOCK/DIMMER once. The time is displayed for 4
seconds.
However, the time cannot be displayed during recording.
l-o swilch to the 24-hour standard
Press ICLOCK/DIMMER once and then press
■ within 4
second f,.
Repeat the same procedure to restore the 12-hour standard.
L.
If the clock display flashes
This is caused by a power interruption, The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
. 44
and * are also avai/ab/e instead of MULTI JOG.
*: //SET is ako avai/ab/e instead of ENTER.
2-
----,, 1
,—
1
2
The unit can be turned off automatically at a specified time.
Use the remote control.
1
2
Press SLEEP while pressing SHIFT.
Within 4 seconds, turn MULTI JOG or press U
or ~ to specify the time until the power is turned
off.
The time changes between 5 and 240 minutes in 5-minute
steps.
Specified time
I
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time
is displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that “SLEEPOFF
appears on the display.
ENGLISH ‘14
