![](http://pdfasset.owneriq.net/6/1e/61ed0ada-1b9a-42c0-aa9d-8ca85e36390e/61ed0ada-1b9a-42c0-aa9d-8ca85e36390e-bg4d.png)
6-6
The Status Screens
The /W command uses the following format:
/W xx [Enter]
Where xx is the desired port number. If the /W command is invoked at a serial port, by
a user with access to Supervisor Level commands, then the letter "N" can be entered as
the command argument to display parameters for the Network Port.
Note: When command mode is accessed via the Network Port using an
account that does not permit Supervisor commands, the /W command will
only display the Sequence Disconnect, Logoff Character, and the status of the
Accept Break item.