Filter
Top Products
13-8
Command Reference Guide
/PW Change Password
When enabled, the /PW command can be invoked by a user/account in order to
change their own password. Note that the /PW command can be enabled/disabled via
the System Parameters command as described in Section 5.4, and that once a given
password has been changed, accounts with Supervisor Level access can still employ
the "Modify User" function to change the password.
Availability: Supervisor / Non-Supervisor
Format:
/PW [Enter]
Response: Displays the Change Password Menu.
/R Read Buffer
Reads from Buffer Mode ports as described in Section 7.3.1. Note that when the /R
command is invoked, the counter for the SNMP Traps function will also be reset.
Availability: Supervisor / Non-Supervisor
Format:
/R <n> [Enter]
Where n is the number or name of the port buffer to be read.
Response: The Read Buffer Menu is displayed.
/S Display Port Status
Displays the Port Status Screen (Figure 6.1), which summarizes conditions and
parameters for all ports. For more information, please refer to Section 6.1.
Availability: Supervisor / Non-Supervisor
Format:
/S [Enter]
Response: Displays Port Status Screen.
/SD Display Port Diagnostics
Provides detailed information regarding the status of each port. When this command is
issued by an account that does not permit Supervisor commands, the resulting screen
will only display parameters for the ports allowed by the account. For more information,
please refer to Section 6.2.
Availability: Supervisor / Non-Supervisor
Format:
/SD [Enter]
Response: Displays Port Diagnostics Screen.
/SN Display Network Status
Displays the Network Status Screen, which lists current conditions and parameters for
the Network Port. For more information, please refer to Section 6.3.
Availability: Supervisor Only
Format:
/SN [Enter]
Response: Displays Network Status Screen