Filter
Top Products
19
Function LED Behavior Description
Surround
On/Off
Surround On:
Surround Off:
Press the Next/Previous button to enable/disable Surround. When enabled (On), the current
input will produce surround sound through all 5.1 channels. When disabled (Off), the current
source will playback on 3.1 channels (Left, Center, Right, and Sub).
DTS TruVolume
On/Off
TruVolume On:
TruVolume Off:
Press the Next/Previous button to enable/disable TruVolume. When enabled (On), TruVolume
provides a consistent and comfortable volume level for a more enjoyable listening experience.
Night Mode On/Off
Night Mode On:
Night Mode Off:
Press the Next/Previous button to enable/disable Night Mode. When enabled (On), the
Sound Bar will lower bass frequency levels to provide a more quiet environment (ideal for
apartment living and homes with sleeping children).
AV Delay
Two LEDs on
the left indicate
no delay.
Press the Next/Previous button to increase/decrease the amount of audio delay. The LED
indicators will move to the right with increasing audio delay levels.
Noise
---
The Sound Bar, Satellite Speakers, and Subwoofer will emit pink noise to ensure that the
system is connected properly. The pink noise will emit in the following sequence: left channel,
center channel, right channel, right satellite speaker, left satellite speaker, and subwoofer.
TV Remote
TV Remote On:
TV Remote Off:
Press the Next/Previous button to enable/disable VIZIO TV Remotes. When enabled (On), you
can use a VIZIO TV remote control to turn on the Sound Bar (using the TV Volume Up button)
and control volume.
Eco Power On/Off
Eco Power On:
Eco Power Off:
Press the Next/Previous button to enable/disable Eco Power Mode. When enabled (On), the
Sound Bar will go into standby after a period of inactivity. The sound bar will automatically turn
off when no audio signal is detected. Off disables this feature.
Note: Enable this function if using a TV remote to control the sound bar.
Program Remote
---
Press the Next/Previous and Play buttons to toggle and select and program your TV remote
to control the Volume Down, Volume Up, and Mute functions on your Sound Bar. See
Programming the Sound Bar
on page 20.
Reset
---
Press the Next/Previous and Play buttons to select and reset your remote and Sound Bar to
the factory default settings. All paired Bluetooth devices will be unpaired. All programmed IR
remotes will also be removed. See
Resetting to Factory Default Settings
on page 21.
When a Dolby
Digital or DTS signal
is detected
Dolby Digital Logo
DTS Logo
Dolby Digital and DTS are only available on either the HDMI, Digital Coaxial Audio In, or Digital
Optical Audio In inputs. When a Dolby Digital or DTS signal is detected, the Dolby Digital or DTS
logo will light up for 5 seconds before fading away.
Surnd
TruVol
Night
VZtvRmt On
EcoPwr On
Prg Remote
Reset No
AV Delay
Noise