Filter
Top Products
Instruction Manual
5
c) Connect the other end of the Cat5e/6 cable (from LINK OUT A) to the LINK IN A
(RJ-45 connector) on the Receiver Unit.
d) Connect the other end of the Cat5e/6 cable (from LINK OUT B) to the LINK IN B
(RJ-45 connector) on the Receiver Unit.
NOTE: If using Cat6 cables, extension distance is limited to 40m (130 ft)
3. Install Receiver Unit
a) Position the Receiver Unit near the video display (i.e. television, projector).
b) Connect the video source to the HDMI® OUT on the Receiver Unit using an
HDMI® cable.
c) (Optional) If you’ve chosen to power the kit from the Receiver side, connect the
provided power supply.
4. Your source video image will now appear on the remote video display.
Operation
Video Adjustment (Receiver Unit Only)
This function allows adjustments in sharpness of the video image for better clarity.
If necessary, adjust the EQ Selector at the Receiver Unit to compensate cable length.
Turn the EQ Selector one notch at one time and wait for 10~12 sec. For HDMI cable
length (Rx-to-monitor) less than 8 meters, the selector position is around 0~7 (depends
on video resolution). For HDMI cable length (Rx-to-monitor) greater than 8 meters,
the selector position is around 8, 9, A~F (depends on video resolution). For example,
if using a 1.8M (or 3.0M) HDMI cable, a CAT5 cable and a display with resolution of
Full HD (1920 x 1080), you may adjust video according to its CAT5 cable length as
following.
CAT5 Cable Length EQ Selector Position
0M~15M 0,1
15M~25M 1,2
25M~30M 2,3