Filter
Top Products
Instruction Manual
7
EDID Factory Default Setting
To avoid confusion in which EDID information has been copied or for more purposes,
this function enables to reset the state to factory default.
Step 1. Use CATx cable for connection between Tx & Rx on Aux RJ-45 Jack. Apply
power to Receiver Unit.
Step 2. Press the button “EDID Copy” and release the button RIGHT AFTER the LED
ashes red.
Step 3. The LED ashes green & red indicating default setting successfully.
DDC Pass Mode
Press the button for more than 15 sec. and release right after the LED ashes green.
The LED lights blue indicating setting successfully. To exit this mode, follow “EDID
Factory Default Setting” steps.