Filter
Top Products
20 | MB Pro1 | MB Pro 2
Using the headset
Restoring factory default settings (Reset)
1. Switch the headset off (see page 14).
2. Keep the multi-function button pressed until the LED alternately flashes blue
and red.
3. Simultaneously press and hold the headset‘s multi-function button and Audio
button for 5 seconds.
The LED flashes 3 times purple and then alternately blue and red. The headset
tries to pair with Bluetooth devices (see page 11).
5 s
3x
6s
OFF
If you are out of the Bluetooth transmission range
Calling is only possible in the Bluetooth transmission range of the mobile phone/
Bluetooth device. The transmission range largely depends on environmental con-
ditions such as wall thickness, wall composition etc. With a free line of sight, the
transmission range of most mobile phones and Bluetooth devices is up to 10
meters.
If the headset leaves the transmission range of the connected Bluetooth device
during a call, one of the following voice prompts is announced in the headset:
• “Phone one disconnected” for the first mobile phone
• “Phone two disconnected” for the second mobile phone or
• “Dongle disconnected” for the Bluetooth dongle.
If you re-enter the Bluetooth transmission range within these 5 minutes, the con-
nection is re-established and the voice prompt “Phone one connected”, “Phone
two connected” or “Dongle connected” is announced in the headset.
If you spend more than 5 minutes outside the Bluetooth transmission range, the
connection breaks down completely and you have to manually re-establish the
connection. To re-establish a connection to the mobile phone or/and Bluetooth
dongle:
X Briefly press the multi-function button.
Once the connection is successfully re-established, one of the following voice
prompts is announced in the headset:
– “Phone one connected” for the first mobile phone
– “Phone two connected” for the second mobile phone or
– “Dongle connected” for the Bluetooth dongle.
1. ”power on“
2. „... connected“