RocketFish RF-GGC001 Video Game Controller User Manual


  Open as PDF
of 2
 
Installing batteries
1 Push the two battery compartment covers down to remove
them.
2 Insert one AAA battery into each battery compartment. Make
sure that the + and – symbols on the batteries match the +
and – symbols in the compartments.
AAA
AAA
3 Replace the covers.
Connecting your controller to your game console
1 For Wii: Open the door on top of the Wii console, then insert
the receiver into the controller socket. See the instruction
booklet for the game you are playing to fi nd out which
socket(s) you need to plug the receiver(s) into. When the
receiver is inserted correctly, the power light turns on and the
RX light fl ashes.
Or,
For GameCube: Insert the receiver into the controller socket
on the front of the console. See the instruction booklet for
the game you are playing to fi nd out which socket(s) you
need to plug the receiver(s) into. When the receiver is inserted
correctly, the power light turns on and the RX light fl ashes.
2 Press the POWER button to turn on the controller. The
controller will pair with the receiver automatically. When
pairing completes, the RX indicator stops fl ashing and lights
solid.
Note: If you want to use more than one controller, you should pair the
controllers one at a time.
Note: If the controller does not automatically connect, follow these
pairing steps in this order:
1 Press and hold the Connect button on the receiver. Do not release.
2 Insert the end of a paperclip into the tiny hole on the back side of
the controller and push. Do not release.
3 Release the Connect button on the receiver.
4 Remove the paperclip from the controller.
Programming a macro
You can program the Z button to perform a series of moves.
1 Press the MACRO button. The indicator on the controller lights
red.
2 Press the Z button.
3 Press the X, Y, A, or B buttons to create the combination of
moves that you want (maximum 16 moves), then press the
MACRO button again to save the macro. (If you make 16
moves, the macro is saved automatically, so you do not need
to press the MACRO button again). The indicator turns off .
4 To run the macro, press the Z button.
5 To erase the macro, press the MACRO button, the Z button,
then the MACRO button again.
Legal notices
FCC/regulatory notices
Changes or modifi cations not expressly approved by the party responsible
for compliance with the FCC Rules could void the user’s authority to
operate this equipment.
90-day limited warranty
Visit www.rocketfi shproducts.com for details
GameCube and Wii are trademarks of Nintendo of America, Inc.
© 2009 Best Buy Enterprise Services, Inc. All rights reserved. All rights
reserved. ROCKETFISH is a trademark of Best Buy Enterprise Services, Inc.
Registered in some countries. All other products and brand names are
trademarks of their respective owners.
ENGLISH 09-0477
 previous