Filter
Top Products
20 Operating and Maintaining the P30 Console
When the equipment is in the Welcome state:
PRECOR scrolls on the lower text display. SELECT A
WORKOUT OR PRESS QUICKSTART TO BEGIN scrolls
in the upper text display.
The heart rate signal is the only segment activated.
On the treadmill, the belt is not moving and the lift motor
is off.
Note: On self-powered equipment, the console initializes
when you begin working out. You must maintain a minimum
rate of motion for the Welcome banner to appear.
The changes made in System Setting modes become the
default settings when the display resets to the Welcome
banner.
CAUTION: If you change the Unit of Measure display on the
treadmill, check the speed setting to verify that it is correct.
To view the Club Parameters settings:
1. At the Welcome banner, press Pause.
2. Press the following number keys in sequence to enter the
password:
5 6 5 1 5 6 5
3. Press OK.
The Set Club Parameters banner appears.
Table 2. Navigational keys for the system setting modes
Key Function
▲ or ▼ Guides you through the settings menu and selections.
OK Select a menu selection.
BACK Returns to the previous menu level without saving
changes.
PAUSE Exits the System Settings mode and returns to the
Welcome banner.