Filter
Top Products
[ 10 ] Pelco Manual C519M-D (7/00)
Table D. Keyboard Functions (continued)
Function Procedure
Sequence* Sequence steps through all 16 cameras. Camera number, camera title,
sequence status, and time/date are shown on the monitor.
Press PREV 4A to step back one camera. Hold for two seconds for a back-
ward sequence. Monitor shows B. Press during sequence to speed up. Press
during a forward sequence to reverse.
Press NEXT 4B to step forward one camera. Hold for two seconds for a for-
ward sequence. Monitor shows F. Press during sequence to speed up. Press
during a backward sequence to go forward.
Press HOLD 4C to hold a sequence. Monitor shows H. Press PREV or
NEXT to resume.
Manually select a camera or press CAM 14 to turn off a sequence. Monitor
shows O.
Macro Sequence* Enter 1 or 2 15 and press MACRO 8 to start a group camera sequence. Moni-
tor shows M. Refer to the CM6700 manual for macro/sequence programming.
Multiplexer Press SHIFT 2 . Shift key LED 3 lights. The function keys F1 through F5
Displays* can now be used to display the images from multiple cameras on the monitor.
F1: Zoom
F2: PIP display
F3: Quad display
F4: 9-screen display
F5: 16-screen display
Auxiliaries/ F1 – F3 5 control only the auxiliaries built into the CM6700 SCU.
Relays These outputs can be programmed for momentary, keyed, latched, or alarm
operation. Refer to the CM6700 manual for programming instructions.
F1: Activate/deactivate auxiliary 1 relay.*
F2: Activate/deactivate switcher auxiliary 2 TTL output.*
F3: Activate/deactivate switcher auxiliary 3 TTL output.*
F4 and F5 control the auxiliaries in receivers.
Enter the auxiliary number and press F4 to turn on. Hold, then release for
momentary functions.
Enter the auxiliary number and press F5 to turn off.
In Direct Mode, F1- F3 5 have no function. LED 1 shows auxiliary num-
ber for two seconds after F4 or F5 5 is pressed.
Acknowledge Press ACK 16 to acknowledge an alarm. Refer to the CM6700 manual for
Alarm* further information on alarms.
Program To program the CM6700 switcher, press PGM 7 .
(CM6700) Follow the programming procedure in the CM6700 manual. LED display 1
shows P in program mode. Press ACK 16 to exit.
LED LED 1 shows monitor number (in CM6700 Mode) or camera/receiver number
(in Direct Mode) and P (in Program Mode).
Firmware Version LED 1 flashes for a few seconds to show firmware version on power up
(not functional on versions prior to 4.0).
Clear Press CLEAR 13 to cancel a number that has been entered.
*This function is not used in Direct Mode.