Filter
Top Products
[ 4 ] Pelco Manual C519M-D (7/00)
INSTALLATION - CM6700 MODE
NOTE:
There are two keyboard ports on the CM6700 SCU. The LOCAL KEYBOARD port cannot be
used for the KBD300V.
To install KBD300V keyboards at the REMOTE KEYBOARD(S) port:
Refer to Figure 2. A KBD300V Interface is used to connect the KBD300V keyboard to the Remote
Keyboard port on the back of the SCU or to another KBD300V Interface in a daisy-chain hookup. It can
also connect to a wall block on either its input side or on its output side. You can have as many KBD300V
keyboards as you have monitor outputs on your SCU.
1 Select a suitable location for the keyboard and interface. The interface must be within 6 feet (1.8 m)
of a suitable electrical outlet and within 6 feet (1.8 m) of the keyboard. Attach the interface to the wall
or other surface with the screws that are provided. Remove the cover if necessary, and replace when
finished.
2 Connect a five-conductor (or larger) cable (user-supplied) from the SCU (or from a wall block or an-
other interface) to the interface. Connect wires at the COM IN terminals. If additional keyboards follow
the KBD300V, connect a cable from the interface output terminals to the next wall block or interface.
3 Connect a video cable from a monitor output on the SCU to the VIDEO IN jack on the interface.
4 Set the keyboard address switches for each keyboard according to the instructions on page 8.
5 Connect the keyboard data cable between the interface and the keyboard.
6 Connect the power supply to the interface and plug the transformer end into a suitable outlet.
7 Turn on the power switch on the back of the keyboard and apply power to the SCU (if not already
powered.
8 To initialize the keyboard, wait five seconds after power up, enter the number for the monitor you are
viewing (1-4), and press MON. The LED display shows the number entered.
NOTE:
You must re-initialize whenever power is cycled.
9 Go to the
Programming and Operation
section and program and test for proper operation.