Filter
Top Products
8 C1620M-B (9/05)
Installation
INSTALLING THE WRIST SUPPORT AND CONTROL MODULES
The KBD5000 comes with three control modules that fit in three receptacles on the base. You can choose which module will be located in which
receptacle, and each module can be rotated ±60 degrees in each receptacle. The KBD5000 also has a wrist support that can be easily installed
and removed. This system allows custom tailoring of the keyboard to your preferences.
A suggested setup is to install the jog/shuttle module on the left side of the base, the keypad module in the center, and the joystick module on
the right.
To install the wrist support and modules, do the following:
1. Remove the base, wrist support, and modules from their packaging.
2. If you want to use the wrist support, do the following (although the keyboard can be used without the wrist support). Refer to Figure 4.
Turn the keyboard upside down. Attach the wrist support by first lining up the four tabs on the wrist support with the four matching screw
receptacles on the base. Install the four supplied screws (Phillips pan head 4-40 x 0.312-inch). Turn the base face up.
Figure 4.
Installing the Wrist Support