Filter
Top Products
10 C1620M-B (9/05)
CONNECTING THE KEYBOARD
To hook up the KBD5000, connect the USB Type B-to-Type A cable (supplied) from the USB connector on the rear of the KBD5000 to the USB
connector on either the front or rear of the Pelco VCD5000 virtual console display or to the USB connector on an Endura Workstation (WS5000
Series). (As an example, Figure 6 shows a connection to either the rear or front of a VCD5000.)
NOTE:
Any USB cable attached to the keyboard must be no longer than 16.4 feet (5.0 m).
Figure 6.
Connecting the KBD5000 to a VCD5000 or a WS5050
TURNING ON THE POWER
To apply power, first insert the power supply’s attached cord into the back of the keyboard and tighten the connector barrel. Then, insert the
appropriate supplied power cord (USA standard, UK standard, or European standard) into the power supply. Finally, insert the power cord’s plug
into a properly grounded power socket. When power is applied, lights on the modules illuminate.
OR
VCD5000 REAR
VCD5000 FRONT (BEZEL OFF)
OR
WS5050 REAR
OR
WS5050 FRONT (BEZEL OFF)
WS5050 REAR