Filter
Top Products
17
GB
Blades with chipped edges must be replaced and must
not be reground because this causes the mower to be
out of balance.
The blade must only be replaced by GARDENA Service
or a specialist dealer authorised by GARDENA.
Only an original GARDENA blade must be used. GARDENA
spares are available from your GARDENA dealer or via
GARDENA Service.
••
GARDENA replacement blade Art. 4091
A damaged or bent blade must be replaced because it will be out
of balance.
Fault Possible cause Remedy
Motor will not start Power supply cable faulty. vCheck power supply cable.
Extension cable may not have a v Use extension cable with
large enough cross-section. cross-section complying with
table (2. For your Safety).
Motor jammed and making Jammed with foreign body. v Switch off motor, pull out
a noise mains plug and remove
foreign body.
Cutting height too low for the v Raise cutting height or
lawn or mowing speed too high. or reduce mowing speed.
Loud noises, mower Screws on motor, its fixing or on v Have screws tightened by an
rattling the mower casing loose. authorised specialist dealer
or GARDENA-Service.
Runs unevenly, mower Blade damaged or blade v Have blade tightened or
vibrates strongly mounting released from motor replaced by an authorised
shaft. specialist dealer or
GARDENA-Service.
Out of balance because of v Clean mower (see
very dirty blade. 6. Maintenance). If this
does not rectify the fault,
contact GARDENA Service.
Lawn is not cleanly cut Blade blunt. v Have blade replaced.
Cutting height too low. v Increase cutting height.
Mowing speed too high. v Reduce mowing speed.
If any other faults occur, please contact GARDENA Service.
Please contact GARDENA Service before sending the
mower. Repairs may only be carried out by GARDENA
service centres or dealers authorised by GARDENA.
Replacing the blade: