Filter
Top Products
Start with the bottom scope. Hold it in one hand, and put the next
scope on top of the 1
st
, the same way around. Align the stacking
connectors and when the stacking connectors are partly mated
engage the front “P” shaped clip (BNC end) on the 2
nd
scope into the
“P” shaped slot on the 1
st
scope.
Now, bring the back edge “P” clip (USB end) of the 2
nd
scope down
until it clicks into the 1
st
scope’s slot. These two scopes are now
mated.
Check that as you pushed the 2
nd
scope down, the stack connector
has not been forced upward…if it has simply press it down until it
seats correctly (see picture above for a guide as to the normal
exposed connector depth after stacking). Repeat this for each
remaining scope, adding each one on top of the previous one.
The scopes are now stacked.
2.3.2 Disassembling The Stack
Start with the top scope in the stack. Grasp the stack in one hand
and with the other hand’s thumb and forefinger, pinch between the
interface between the top two scopes, near the back “P” clip (USB
end). With moderate force, the top scope will pop up and come free.
Remove the stacking connector from the free scope.
Repeat this for all scopes in the stack.
Elan Digital Systems Ltd. 10 USBscope50 USER’S GUIDE Iss5