Filter
Top Products
Using the Configuration Interface
10 D-Link Systems, Inc.
Using the Configuration Interface
Requirements for using the DGL-3420’s Web Configuration Utility
If you are incorporating the DGL-3420 into a network that contains all D-Link devices, you do not
need to use the Web Configuration utility. With its default settings, the DGL-3420 will connect with
other D-Link 802.11a, 802.11b or 802.11g devices that are set to their default settings, with no
configuration needed!
If your network contains devices other than D-Link devices, or if you wish to configure the
DGL-3420, you will need to do the following before using the Web Configuration Utility:
You will need a Java-enabled Web browser such as the Internet Explorer 6.0 or later, or the
Netscape Navigator 7.0 or later.
You will need to assign to your PC an IP address within the network of the DGL-3420. For example,
you can assign a static IP address of 192.168.0.2 and a subnet mask of 255.255.255.0 to the
computer that you will use for configuration.
(Please refer to the Troubleshooting section of this manual for more information.)
1
2
Operating Mode:
Infrastructure
SSID:
default
Channel:
6
Transmission rates:
Auto
Encryption:
Administrator Password:
No
IP Address Mode:
Static
IP Address:
IP Subnet:
username:
admin
255.255.255.0
192.168.0.30
Factory Default Settings for the DGL-3420
Blank (no password needed)