Filter
Top Products
QUICK INSTALLATION GUIDE
Remote Management Card
RMCARD202
I
ntelligent Remote Management Card allows a UPS
system to be managed, monitored, and configured
K09-0000064-01
INSTALLATION GUIDE
5. Connect the Ethernet cable
to the LAN port of the
CyberPower Remote
Management Card.
6. Turn on the UPS.
4. Re-install and tighten the
retaining screws.
3. Install the CyberPower
Remote Management Card
into the expansion port.
2. Remove the two retaining
screws of the expansion port
cover , then remove the cover.
1. Turn off the UPS before
removing the expansion port
cover on the UPS.
Definitions for LED Indicators
Step 2. Configure the IP address for the CyberPower
Remote Management Card.
Method 1: Using the Power Device Network Utility Tool
1. Install the Power Device Network Utility Tool from the included CD. It is
located on the CD in the \tools\network folder. Double click the “Power
Device Network Utility” installation file, “Setup.msi”to begin the
installation.
2. After installation is complete, run the “Power Device Network Utility”
. (Under “All Programs”, select “CyberPower Power Device Network
Utility”).
3. The main dialog of the Power Device Network Utility Tool program is
shown in Figure 1. The tool will display all Remote Management
Cards present on the network. The "Refresh" button is used to
search the entire local network again.
4. Select the Remote Management Card you are setting up. Click on the
Tools manual and select “Device Setup” or double click the Remote
Management Card you want to configure.
5. You can modify the IP
Address, Subnet Mask, and
Gateway address for the
Device MAC Address listed in
the Device Network Settings
window, as shown in Figure 2.
6. Modify the IP, subnet mask
or gateway address. Enter
the new addresses into the
corresponding fields.
Link LED color
Off
On(Yellow)
TX/RX LED color
Off
On(Green)
Flash
Condition
The Remote Management Card is not
connected to the Network or the Remote
Management Card power is OFF
The Remote Management Card is
connected to the Network
The Remote Management Card power is OFF
The Remote Management Card power is ON
- Receiving/transmitting data packet
- Reset finished
RMCARD202
RX/TXLink
Ethernet connector
LINK Indicator
RX/TX Indicator
Figure 1. The main window of the “Power Device Network Utility” program.
Figure 2. The Device Network setting window.
Step 1. Hardware Installation