Filter
Top Products
Alacritech Scalable Networking Accelerator Hardware Installation Guide (Copper) 2-2
2.2 Installing the Low Profile Bracket (PCI and PCI-X Accelerators Only)
The Accelerator includes a low profile bracket to facilitate installation in a low
profile slot. To install an Accelerator in a low profile PCI slot, the bracket on the
rear of the card will need to be changed with the included low profile bracket.
1. Remove the two 4-40 x 3/16 screws on the bottom side of the card.
2. Install the low profile PCI bracket, making sure that the mounting tabs are on
the bottom side of the card and the screws secured from the component (top)
side.
To convert an Accelerator from low profile to standard PCI, the bracket on the
rear of the card will need to be changed to the original bracket.
1. Remove the two 4-40 x 3/16 screws from the topside of the card.
2. Install the standard PCI bracket, making sure that the mounting tabs are on the
top (component) side of the card and the screws secured from the bottom side.