Filter
Top Products
Language Dictionary - 8
113
OUTPut:PROTection:CLEar
This command clears the latch that disables the output when an overvoltage, overcurrent,
overtemperature, or remote inhibit status condition is detected. All conditions that generate the fault must
be removed before the latch can be cleared. The output is then restored to the state it was in before the
fault condition occurred.
Command Syntax
OUTPut:PROTection:CLEar
Parameters
None
Examples
OUTP:PROT:CLE
Related Commands
OUTP:PROT:DEL *RCL *SAV
OUTPut:PROTection:DELay
This command sets the time between the programming of an output change that produces a constant
current condition (CC) and the recording of that condition by the Operation Status Condition register.
The delay prevents the momentary changes in status that can occur during reprogramming from being
registered as events by the status subsystem. Since the constant current condition is used to trigger
overcurrent protection (OCP), this command also delays OCP. Overvoltage protection is not affected by
this command.
Command Syntax
OUTPut:PROTection:DELay <NRf+>
Parameters
0 to 2,147,483.647
Unit
seconds
*RST Value
0.08 (Normal)
Examples
OUTP:PROT:DEL 75E-1
Query Syntax
OUTPut:PROTection:DELay?
Returned Parameters
<NR3>
Related Commands
OUTP:PROT:CLE CURR:PROT:STAT *RCL *SAV
OUTPut:RI:MODE
This command selects the mode of operation of the Remote Inhibit protection. The RI mode is stored in
non-volatile memory. The following modes can be selected:
LATChing
causes a TTL low signal on the INH input to disable the output. The only way to clear
the latch is by sending OUTPut:PROTection:CLEAR while the INH input is false.
LIVE
allows the INH input to disable the output in a non-latching manner. In other words,
the output follows the state of the INH input. When INH is low true, the output is
disabled. When INH is high the output is not affected.
OFF
the INH input is disabled.
Command Syntax
OUTPut:RI:MODE <mode>
Parameters
LATChing | LIVE | OFF
Examples
OUTP:RI:MODE LIVE
Query Syntax
OUTPut:RI:MODE?
Returned Parameters
<CRD>
Related Commands
OUTP:PROT:CLE