Filter
Top Products
1-2
SAFETY SUMMARY
The following general safety precautions must be observed during all phases of operation, service, and repair of this instrument.
Failure to comply with these precautions or with specific warnings elsewhere in this manual violates safety standards of design,
manufacture, and intended use of the instrument. Agilent Technologies assumes no liability for the customer's failure to comply
with these requirements.
BEFORE APPLYING POWER.
Verify that the product is set to match the available line voltage
and that the correct fuse is installed.
GROUND THE INSTRUMENT.
This product is a Safety Class I instrument (provided with a pro-
tective earth terminal). To minimize shock hazard, the instrument
chassis and cabinet must be connected to an electrical ground.
The instrument must be connected to the ac power supply mains
through a three-conductor power cable, with the third wire firmly
connected to an electrical ground(safety ground) at the power
outlet. Any interruption of the protective(grounding) conductor or
disconnection of the protective earth terminal will cause a poten-
tial shock hazard that could result in personal injury. If the instru-
ment is to be energized via an external autotransformer for
voltage reduction, be certain that the autotransformer common
terminal is connected to the neutral(earthed pole) of the ac power
lines (supply mains).
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE.
Do not operate the instrument in the presence of flammable
gases or fumes.
KEEP AWAY FROM LIVE CIRCUITS.
Operating personnel must not remove instrument covers. Compo-
nent replacement and internal adjustments must be made by
qualified service personnel. Do not replace components with
power cable connected. Under certain conditions, dangerous volt-
ages may exist even with the power cable removed. To avoid inju-
ries, always disconnect power, discharge circuits and remove
external voltage sources before touching components.
DO NOT SERVICE OR ADJUST ALONE.
Do not attempt internal service or adjustment unless another per-
son, capable of rendering first aid and resuscitation, is present.
SAFETY SYMBOLS
Instruction manual symbol; the product will
be marked with this symbol when it is neces-
sary for the user to refer to the instruction
manual.
Indicate earth(ground) terminal.
The WARNING sign denotes a hazard. It
calls attention to a procedure, practice,
or the like, which, if not correctly performed or
adhered to, could result inpersonal injury. Do
not proceed beyond a WARNING sign until
the indicated conditions are fully understood
and met.
The CAUTION sign denotes a hazard. It calls
attention to an operating procedure, or the
like, which, if not correctly performed or
adhered to, could result in damage to or
destruction of part or all of the product. Do
not proceed beyond CAUTION sign until the
indicated conditions are fully understood and
met.
The NOTE sign denotes important infor-
mation. It calls attention to a procedure, prac-
tice, condition or the like, which is essential to
highlight.
DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT.
Because of the danger of introducing additional hazards, do not
install substitute parts or perform any unauthorized modification
to the instrument. Return the instrument to a Agilent Technologies
Sales and Service Office for service and repair to ensure that
safety features are maintained.
Instruments that appear damaged or defective should be made inoperative and secured against unintended
operation until they can be repaired by qualified service personnel.
!
or
CAUTION
WARNING
NOTE