12
MZ Series User Guide
When the battery is first installed, the printer power and
charge indicators should indicate the battery is not fully
charged (see “Charging the Battery” below and “Operator
Controls”).
You must charge the battery fully before using the printer for the rst
time.
Charging the Battery
Preparing the Charger Power Supply
Before charging the battery for the first time, you must pre-
pare the Charger Power Supply. Refer to Figure 3 below:
Figure 3: Preparing the Charger Power Supply
continued
1. Remove the power sup-
ply from its box. Remove
and discard the shipping
ring from the mains recep-
tacle cavity.
Shipping Ring
Remove and discard
2. Verify that the mains adapter
shipped with your Printer is the correct
one for your region.
Mains Adapter
3. Install the mains adapter into
the Power Supply by hooking
the top edge into the mains
receptacle cavity, and rotating
it until it snaps into place.
US/Japan-100-110 VAC
China-220 VAC
UK -230 VAC
Euro -230 VAC
Aust-240 VAC
