Before starting
your dishwasher
1. Spin the Upper Spray Arm to make sure
nothing will stop it from turning freely.
2. Close the door. Do not latch it. If it
latches, press in the door latch under the
Control Panel to unlatch.
3. Run hot water at sink nearest dishwasher
until it is hot. Turn if off.
CLEAN SELECTOR BUTTONS
OPTION SELECTOR BUTTONS
Starting your dishwasher
1. Push a Clean Selector Button for the de-
- POTS & PANS and HEAVY WASH Cycles
sired cycle.
share the same spot on the dial. The
2. Push Option Selector Button for desired
Clean Selector Button determines
option or options. (Use AIR DRY for RINSE
which cycle operates.
& HOLD Cycle.]
4. Push door firmly to latch it. The dish-
3. Turn Cycle Control Knob clockwise to
washer will automatically start the se-
point to a desired cycle. You will feel a
lected cycle.
definite stop at each cycle mark.
The AIR DRY Option
Air in the dishwasher is automatically heated
during the “dry” pat-t of all cycles.
If the AIR DRY Option is selected, air in the
dishwasher is not heated. Using this option helps
save energy, but dishes take longer to dry (over-
night] and some water spotting may result.
Some items (such as plastics] may need towel
drying.
For best results, use a liquid rinse aid such as
Jet-Dry:”
HI-TEMP WASHING Option
If the water is alreadv hot enouah. the cvcle
When this option is selected, water for the
continues without delay. The WATER HEAYING
main wash and the final rinse is heated to145”F
HOLD Signal Light will be on while the cycle de-
(63°C).
lays for water heating.
Using DELAY START
4. Close and latch the door. The DELAY WASH
Signal Light will come on until the selected
cfcle St&s.
NOTES:
l
You can add items while time is counting
down. Close and latch the door. The timer will
not advance if the door is unlatched.
l
RINSE & HOLD and LOW ENERGY WASH Cycles
can’t be delayed.
1. Push desired Clean Selector Button.
2. Push desired Option Selector Buttons.
3. Turn Control Knob clockwise to the number of
hours (from 1 to 6 hours) you want the dish-
washer to delay before the selected cycle
starts
To add a dish after starting
1.
To be sure the added item is washed and
rinsed, make sure the Cycle Control Knob
has not passed LOW ENERGY WASH.
2. Unlatch the doorto stop the cycle.
3. Open the door and add the dish.
4. Close the door. Do not latch it. Wait 30 sec-
onds for air in the dishwasher to warm up.
This helps reduce the amount of moisture
that can come from the vent when restart-
ing the cycle.
5. Latch the door. The dishwasher will start
from where it stopped.
The CLEAN Signal Light
To turn it off. Turn the Control Knob clockwise
The CLEAN Signal Light will come on when a slightly until the light goes off Do not pull out
washing cycle is complete. the Control Knob.
8
